van_inkscape_naar_fusion_360_met_de_juiste_schaal [Maakplek]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== From Inkscape to Fusion 360 without scaling issues ======

Importing from Inkscape to Fusion 360 is easy, just go in Fusion to Insert > Insert SVG/Insert DXF. But raaahhrggghh, the scale is completely off!

To make them compatable with each other, you have to adjust 2 settings in Inkscape:

  * Scaling from millimeter to pixels
  * Use the Geometric bounding box

===== From mm to px =====

  Open the Document Properties with Cntr + Shift + D.
  Put the Display Units from mm to px. 
  Put in the box Scale, Scale-x to 1.0. 
  Put the Display Units back from px to mm. The scale will automatically change, don't adjust it anymore.
  Give your drawing the right dimensions again.

Extra tip: You can also adjust the Page Size to your drawing size in Document Properties. In the box Costum Size click on " + Resize page to content..." And then click on Resize page to drawing or selection.

Now you are almost there. If you would import your drawing in Fusion now, you'd be off by less than a millimeter.

===== Use the Geometric Bounding Box =====

Inkscape thinks that you want te size of all the pixels that you see, including the stroke lines. (For example, your drawing is 100 mm wide, you have selected a stroke width of 1 mm, your size is 101 mm).

  To make Inskcape clear that you don't want that, go to: 
  Edit > Preferences (or Cntr + Shift + P) > Click on Tools > Select Geometric Bounding Box


That should do it! Go ahead and import to Fusion 360.

===== Still not working? =====
Is the difference a factor of 1.0666666? Than your pixels are probably defined differently. Inkscape used to have 90 dots per inch (DPI), but changed it to 96. Fusion might still thing you are using the 90 DPI. 
You can change this by going to: Extensions > Document > 96 to 90 DPI.

User Tools

Site Tools

Page Tools