This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
cpm4030 [2023/06/12 10:19] – [Electronica - Endswitches] wrusman | cpm4030 [2024/01/19 11:40] – wrusman | ||
---|---|---|---|
Line 299: | Line 299: | ||
</ | </ | ||
+ | === "Probe Z" voor gebruik met de toolsetter v2 (kan nog beter?)=== | ||
+ | < | ||
+ | G91 G21 ; (Relative position in mm.) | ||
+ | G38.2 Z-70 F100 ;(Search of the probe on 70 mm. speed 100, if not found after 70 mm. Alarm GRBL) | ||
+ | G0 Z2 ; (back 2mm.) | ||
+ | G38.2 Z-2 F50 ; (Searching the probe for 2 mm, slower, speed 50) | ||
+ | G92 Z65 ; (Adjustment of the Z offset according to the thickness of the probe, 65 mm in this case) | ||
+ | G0 Z75 ; (back 10mm.) | ||
+ | M0; (pause) | ||
+ | </ | ||
- | + | === "Ga naar positie x1 y1"=== | |
+ | < | ||
+ | G90 G20 | ||
+ | G0 X1 Y1 | ||
+ | </ |