This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
cpm4030 [2023/06/12 10:19] – [Electronica - Endswitches] wrusman | cpm4030 [2024/01/19 12:14] – wrusman | ||
---|---|---|---|
Line 54: | Line 54: | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
CAM in bestaande tekensoftware : | CAM in bestaande tekensoftware : | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | Grafische truukjes : | ||
+ | [[https:// | ||
+ | [[https:// | ||
+ | [[picsvg.com | plaatjes naar svg]] | ||
+ | |||
problemen met arcs: | problemen met arcs: | ||
Line 82: | Line 89: | ||
[[http:// | [[http:// | ||
+ | {{: | ||
+ | [[https:// | ||
Line 299: | Line 307: | ||
</ | </ | ||
+ | === "Probe Z" voor gebruik met de toolsetter v2 (kan nog beter?)=== | ||
+ | < | ||
+ | G91 G21 ; (Relative position in mm.) | ||
+ | G38.2 Z-70 F100 ;(Search of the probe on 70 mm. speed 100, if not found after 70 mm. Alarm GRBL) | ||
+ | G0 Z2 ; (back 2mm.) | ||
+ | G38.2 Z-2 F50 ; (Searching the probe for 2 mm, slower, speed 50) | ||
+ | G92 Z65 ; (Adjustment of the Z offset according to the thickness of the probe, 65 mm in this case) | ||
+ | G0 Z75 ; (back 10mm.) | ||
+ | M0; (pause) | ||
+ | </ | ||
- | + | === "Ga naar positie x10 y10" | |
+ | < | ||
+ | G90 G21; (Absolute position in mm.) | ||
+ | G0 X10 Y10; | ||
+ | </ |