Differences

This shows you the differences between two versions of the page.

--- cpm4030 [2024/01/19 11:23] – wrusman
+++ cpm4030 [2024/01/19 11:40] – wrusman
@@ Line 302: / Line 302: @@
 <code>
 G91 G21 ; (Relative position in mm.)
-G38.2 Z-70 F100 ;(Search for the probe 70 mm speed 100. If not found after 70mm, alarm GRBL)
+G38.2 Z-70 F100 ;(Search of the probe on 70 mm. speed 100, if not found after 70 mm. Alarm GRBL)
-G0 Z2 ; (back 2.mm)
+G0 Z2 ; (back 2mm.)
-G38.2 Z-3 F30 ; (Search for the probe 3 mm; slower - speed 30)
+G38.2 Z-2 F50 ; (Searching the probe for 2 mm, slower, speed 50)
-%wait%
+G92 Z65 ; (Adjustment of the Z offset according to the thickness of the probe, 65 mm in this case)
-G20
+G0 Z75 ; (back 10mm.)
-%wait%
+M0; (pause)
-G10 L20 P1 Z0.593
-%wait%
-G0 Z.5
-G90 G21
-M0
 </code>
+=== "Ga naar positie x1 y1"===
+<code>
+G90 G20
+G0 X1 Y1
+</code>