This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
profiler [2018/01/25 09:21] – wrusman | profiler [2018/01/25 09:34] – wrusman | ||
---|---|---|---|
Line 38: | Line 38: | ||
{{: | {{: | ||
+ | |||
+ | In de arduino is Grbl (Gerbil) gezet voor aansturing. https:// | ||
+ | Dit werkt als " | ||
===== Electronica - Toolsetter ===== | ===== Electronica - Toolsetter ===== | ||
Line 44: | Line 47: | ||
===== Software ===== | ===== Software ===== | ||
- | ==== Grbl (Gerbil) ==== | + | === GCode Simulator : === |
- | https://github.com/gnea/ | + | http://camotics.org/ |
- | + | ||
- | === voordelen : === | + | |
- | - redelijk grote community | + | |
- | - draait op arduino | + | |
- | - USB communicatie | + | |
- | - Netwerk communicatie mogelijk | + | |
- | - meerdere gcode streamers beschikbaar voor meerdere platformen | + | |
- | + | ||
- | === Nadelen : === | + | |
- | - maakt gebruik van aparte GCode streaming software, geen uniforme interface dus | + | |
- | - Veel soorten en smaken forks beschikbaar, | + | |
=== GCode Streamers : === | === GCode Streamers : === | ||
+ | Gcode streamers zijn bijna hetzelfde als 3D printer software die coördinaten naar de printer sturen vanaf de pc alleen zijn deze versies voornamelijk bedoeld voor Frezen of lasersnijden. | ||
+ | |||
{{: | {{: | ||
[[https:// | [[https:// |