This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
scan_n_cut [2022/10/26 11:50] – created jolien | scan_n_cut [2022/10/26 11:59] (current) – jolien | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | How to Brother Scan 'n Cut | + | =======How to Brother Scan 'n Cut======= |
- | It can scan, it can cut, it can even brother! | + | It can scan, it can cut, it can even brother! |
+ | {{ :: | ||
+ | This machine was gifted/lent by Mariette <3 | ||
+ | |||
+ | =====What materials can it cut?===== | ||
+ | * paper | ||
+ | * fabric | ||
+ | * vinyl | ||
+ | * stickerspaper | ||
+ | * tatoopaper | ||
+ | * plastic sheet | ||
- | This machine was gifted/lent by Mariette <3 | + | =====What knife do you use for what?===== |
- | + | ||
- | What materials can it cut? | + | |
- | * paper | + | |
- | * fabric | + | |
- | * vinyl | + | |
- | * stickerspaper | + | |
- | * tatoopaper | + | |
- | * plastic sheet | + | |
- | + | ||
- | What knife do you use for what? | + | |
Knives dull pretty quickly, depending on the material you cut. I think there is one knife for normal use, if you want to cut more exiting materials, it's nice if you buy your own knife. | Knives dull pretty quickly, depending on the material you cut. I think there is one knife for normal use, if you want to cut more exiting materials, it's nice if you buy your own knife. | ||
- | Instructions | + | =====Instructions===== |
For more elaborate instructions watch some youtube tutorials! | For more elaborate instructions watch some youtube tutorials! | ||
- | * Stick you material to the sticky sheet | + | |
- | * Load the sheet by pressing the middle button that looks like its loading a raster (insert pic) | + | * Load the sheet by pressing the middle button that looks like its loading a raster (insert pic) |
- | * Load your svg from a USB stick, laptop or other data connection | + | * Load your svg from a USB stick, laptop or other data connection |
- | * Scan you sheet, so the machine knows where the material is | + | * Scan you sheet, so the machine knows where the material is |
- | * Select where you want to cut | + | * Select where you want to cut |
- | * Check your settings, for the cutting pressure, auto is a good setting. Make sure you select cut or half-cut | + | * Check your settings, for the cutting pressure, auto is a good setting. Make sure you select cut or half-cut |
- | * Start! | + | * Start! |
- | * Make sure your material doesn' | + | * Make sure your material doesn' |
- | * Unload the sheet by pressing the middle button that looks like its loading a raster (insert pic) | + | * Unload the sheet by pressing the middle button that looks like its loading a raster (insert pic) |
- | How to use the pen plotter? | + | =====How to use the pen plotter?===== |
Idk yet | Idk yet | ||