config.yaml
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| config.yaml [2026/08/13 18:51] – wrusman | config.yaml [2026/09/25 00:13] (current) – wrusman | ||
|---|---|---|---|
| Line 86: | Line 86: | ||
| step_pin: gpio.26 | step_pin: gpio.26 | ||
| direction_pin: | direction_pin: | ||
| - | disable_pin: | ||
| - | motor1: | ||
| - | null_motor: | ||
| - | |||
| - | a: | ||
| - | steps_per_mm: | ||
| - | max_rate_mm_per_min: | ||
| - | acceleration_mm_per_sec2: | ||
| - | max_travel_mm: | ||
| - | soft_limits: | ||
| - | homing: | ||
| - | cycle: -1 | ||
| - | allow_single_axis: | ||
| - | positive_direction: | ||
| - | mpos_mm: 1.000 | ||
| - | feed_mm_per_min: | ||
| - | seek_mm_per_min: | ||
| - | settle_ms: 500 | ||
| - | seek_scaler: | ||
| - | feed_scaler: | ||
| - | motor0: | ||
| - | hard_limits: | ||
| - | pulloff_mm: 5.000 | ||
| - | standard_stepper: | ||
| - | step_pin: gpio.23 | ||
| - | direction_pin: | ||
| disable_pin: | disable_pin: | ||
| motor1: | motor1: | ||
| Line 152: | Line 126: | ||
| Relay: | Relay: | ||
| - | output_pin: gpio.5 | + | output_pin: gpio.4 |
| - | direction_pin: | + | direction_pin: |
| enable_pin: NO_PIN | enable_pin: NO_PIN | ||
| disable_with_s0: | disable_with_s0: | ||
| Line 161: | Line 135: | ||
| tool_num: 0 | tool_num: 0 | ||
| off_on_alarm: | off_on_alarm: | ||
| - | | + | </ |
config.yaml.1786639867.txt.gz · Last modified: by wrusman