Differences

This shows you the differences between two versions of the page.

--- from_inkscape_to_fusion_without_scaling_issues [2020/02/23 11:54] – [Still not working?] jolien
+++ from_inkscape_to_fusion_without_scaling_issues [2020/02/26 12:21] – Make it a list and make some text emphasis clemens
@@ Line 10: / Line 10: @@
 ===== From mm to px =====
-  Open the Document Properties with Cntr + Shift + D.
+  - Open the Document Properties with ''Ctrl + Shift + D''.
-  Put the Display Units from mm to px.
+  - Put the **Display Units** from ''mm'' to ''px''.
-  Put in the box Scale, Scale-x to 1.0.
+  - Put in the box Scale, Scale-x to 1.0.
-  Put the Display Units back from px to mm. The scale will automatically change, don't adjust it anymore.
+  - Put the Display Units back from px to mm. The scale will automatically change, don't adjust it anymore.
-  Give your drawing the right dimensions again.
+  - Give your drawing the right dimensions again.
-Extra tip: You can also adjust the Page Size to your drawing size in Document Properties. In the box Costum Size click on " + Resize page to content..." And then click on Resize page to drawing or selection.
+Extra tip: You can also adjust the ''Page Size'' to your drawing size in Document Properties. In the box Custum Size click on " + Resize page to content..." And then click on ''Resize page to drawing or selection''.
 Now you are almost there. If you would import your drawing in Fusion now, you'd be off by probably less than a millimeter.